V2.7 Fixed to be able to takeoff with crosswind. (when AUTO-RUDDER is off)
Please Delete the Old Version and replace it.
----------------------------------------
This is a Milviz F-86 flight model modified for Aerobatics V2.7.
Required aircraft: Milviz conversion F-86
https://flightsim.to/file/64410/milviz-f-86-sabre-full-aircraft-partial-native-conversion
Many thanks to Milviz and the conversion author.
I modified the turning performance with reference to the F-86's video, but it is not an accurate flight model.
Sorry, I cannot accept requests.
Editing Flight_model.CFG is easy with Notepad.
( Roll and Pitch rate )
Open Flight_model.cfg in a text editor.
Increasing the value will make it faster.
elevator_effectiveness =1.8
aileron_effectiveness =2.9
I recommend ASSISTED YOKE - OFF
If set to ON , there will be unnecessary responses.
OFF is better for your controls to be accurate.
ASSISTED CONTROLLER SENSITIVITY - ON / OFF
This setting also affects controllability. Roll sensitivity may be changed depending on the MSFS system.
Controlling with keyboard seems a bit difficult, so a joystick is best.
Change Camera:
CTRL + 1 , 2, 3, 4, 5 ... key or CTRL + 1 then A key ( Next View ).
You can revert to the original flight model at any time.
Before downloading, you can watch the flight model of this file in the video below.
< Installation and Addon priority >
Please Delete the Old Version and replace it.
Copy " F86-flightmodel_aero " folder to the Community folder.
( not " f86-aerobatic-v2 " folder )
If you have downloaded version 1.0, please delete it.
If this aerobatic mod is in your Community folder but is not prioritized, Cockpit will not be visible.
Please be careful when changing the add-on folder name.
-- Folder name priority within Community folder --
Top priority alphabet "Z"
Lowest alphabet "A"
< Milviz Conversion / DC Designs F-4 Phantom II Flight Model >
https://flightsim.to/file/70627/milviz-conv-dc-designs-f-4-phantom-high-power-f4-flight-model-cfg
5 months ago
5 months ago
Ter2255
DennisP
Just a thought - nothing about the model, but about the naming convention that you've used.
This has to do with changing the name of the addon to reflect the version number.
By doing so, you are causing some of us users a bit of a problem.
Each time you release a new version with, effectively, a new name, it doesn't show up in My Downloads as an existing download needing an update - which means that I won't pick it up in there as needing an update, and, it doesn't show up as an update, but rather as a "new" addon.
This is meant as constructive criticism, and if you could see your way clear to updating your addons without changing the file / page name, I'm sure that it would help a lot of people.
Thanking you in anticipation.
John G
5 months ago
5 months ago
Ter2255
JohnG